Home > Beginner Project Plans > Tambour Clock Free Project Plan

Tambour Clock Free Project Plan

This is an exact copy of an antique tambour clock (circa 1910). I usually find tambour clocks quite ugly, but this particular one has very nice lines. I liked it so much, I took the original design and reduced it in size. I think that made at this size, it especially makes a very attractive clock.

Instructions

Step 1
If you don't have a piece of wood four inches thick you will have to glue up material to get the thickness.

Step 2
Lay out and transfer the shape of the body, part number 1, to the wood. Carefully cut and sand all surfaces. Keep all of the edges sharp.

Step 3
Cut and route the 1/8-inch radius in the base.

Step 4
Lay out and cut the small moulding piece, part number 3. I laid out the inner edge only and cut it out. I then cut the 1/8-inch-radius cove cut. After the inside cuts are made, I made the outer edge cut. By doing it this way, you have something to hold on to while making the 1/8-inch-radius cove cut.

Step 5
Locate and drill the hole for the insert.

Step 6
Glue the moulding, part number 3, to the body, part number 1. Sand the edge.



Step 7
Add the base, part number 2.

Step 8
Sand and finish to suit.

Step 9
Add the four feet, parts number 5.

Step 10
Fit and insert the movement, and set the correct time. Your "new" antique is ready to be used for years to come.

No.	Name	Size	Required
1	Body	1 1/2 x 4 - 9 Long	1
2	Base	1/2 x 1 7/8 - 10 Long	1
3	Molding	3/16 x 2 - 4 1/4 Long	1
4	Insert Movement	2 13/16 Bezel Dia.	1
5	Foot	1/2 Dia.	4

 
  © 2011 Woodworkit - Woodworking Resource. All Rights Reserved. Contact